Spades Muscat

Non-return type Inside Blow Out Preventor is suitable for use on drill pipe which has spring loaded type valve & seat mechanism to shut off the pressure from drill string. During normal operation it allows downward flow of circulation material coming thru mud pump, stand pipe, rotary swivel & drilling hose but prevent upward flow when circulation stops. When back flow occurs valve closes automatically & stabbing to its position and thus not only protects mud pump, stand pipe, rotary swivel, drilling hose from damage but also prevents blow out.

Releasing Tool is used to remove a latched device from ‘S’ and ‘R’ type pulling tools without removing the shear pin.

We are one of the largest suppliers of chemicals to a variety of industries. We supply a wide range of performance chemicals to every application sector within oilfield: drilling, cementing, stimulation, production and EOR (Enhanced Oil Recovery).

Toolstring Clamp is placed around standard toolstring fishing necks. The supporting arms rest on the box section of the wireline valve or riser to allow extended toolstring make-up.

The purpose of the gas lift valve probe tester is to determine the relative "stiffness" of a gas lift valve and to determine the maximum available travel of the stem top. When gas pressure is admitted to the tester, it acts on the full area of the valve bellows to lift the stem off the seat. When this pressure increased, the stem tip lifts further off the seat. By using the valve probe tester, an accurate measure of the stem tip travel, per pressure increase, can be determined and the results tabulated and plotted. When the pressure is plotted as the ordinate and the stem tip travel as the abscissa, a relatively straight line will be generated for the majority of the stem tip travel. The slope of this line is an indication of the "stiffness" of the valve. The numerical value of the slope is called the bellows assembly load rate (blr) and is measured in psiginch [kpamm]. In this context, the "bellows assembly" includes the bellows and the system which applies a load to hold the valve stem on the seat.

Two basic motor valve designs, the MV-40 and the MV-60. Both models are pneumatically operated valves for use in time cycle controllers, dump valves for oil and gas separators, pressure vessels, and storage tanks; and various wellhead and process control applications. The MV-40 is an economical motor valve designed for applications where the maximum working pressure does not exceed 3, 000 pounds per square inch. The MV-60 is specified for service up to 4, 000 pounds per square inch working pressure. Both models are available in 1 in. or 2 in. body size, angle or through configuration with welded, flanged, or threaded ends.